Chapter 4: Rear Panel Connectors; Analog I/O; Mic Inputs 1-24 - Mackie tt24 Owner's Manual

Mackie TT24 Digital Live Console Owner's Manual

Chapter 4: Rear Panel Connectors

4.1

Analog I/O

Figure 4-1 shows the rear panel analog I/O connectors except for the Group/
Matrix outputs, which are shown in Figure 4-3.
15 14 13
LINE LINE LINE
INSERT INSERT INSERT
MAINS OUT TALKBACK
LEFT RIGHT CTR/MONO C
Main Outputs Talkback
Input
4.1.1 MIC Inputs 1–24
The TT24 microphone preamp was based on our extensive knowledge and
experience with those used in the Digital 8•Bus, VLZ Pro, and Onyx Series
mixers, but optimized for a digital mixer.
These female XLR connectors accept a balanced microphone input from almost
any type of microphone. The LINE button on the channel strip should be in the
up
position when using these connectors. The MIC inputs appear on the ANALOG
fader bank. Phantom power (48 VDC) can be switched on for condenser mics
setting the 48V button to the
The XLR inputs are wired according to the AES standard :
• Pin 1 = Shield or ground
• Pin 2 = Positive (+ or hot)
• Pin 3 = Negative ( - or cold)
12 11 10 9
LINE LINE LINE LINE
INSERT INSERT INSERT INSERT
CD/TAPE A
L
12 11
R
IN OUT
L R
CD/Tape A CD/Tape B
Inputs/Outputs Inputs
8 7 6
LINE LINE LINE
INSERT INSERT INSERT
AUX SENDS
10 9 8 7 6
LINE INPUTS
8 7 6 5 4
8 Analog Line Inputs
Figure 4-1 Analog I/O
down
position.
43
5 4 3 2
LINE LINE LINE LINE
INSERT INSERT INSERT INSERT
5 4 3 2
MONITOR
3 2 1 L
1
LINE
24 Mic, Line
and Insert
Analog
INSERT
Inputs
12 Aux
Sends
1
Monitor
Outputs
R M