Mount And Wire Eim; Install Eim; Eim Wiring; Install Return Air Sensor (Optional) - Honeywell RedLink Installation Manual

1

Mount and wire EIM

Mount EIM on wall near HVAC equipment, or on the equipment itself.
Do not install inside HVAC equipment. Use screws & anchors as appropriate
for mounting surface.

Install EIM

EIM wiring

Español: vea la página 20 • Français : voir la page 39

Install return air sensor (optional)

The return air sensor maintains safe indoor
temperature if thermostat power is lost.
Install sensor on return air duct at least 12"
(305mm) upstream from ventilator, humidifier
or dehumidifier (do not mount downstream)
Strip 1/4" insulation, then insert wires
as shown.
Press tabs only to remove wires from
terminal block if necessary.
Wiring must comply with local electrical codes.
3
Drill 1/4" hole
(6.4mm)
Continued on next page >>