Install Batteries In Wireless Devices; Link All Devices To Wireless Network; Thermostat; Remote Control (Optional) - Honeywell RedLink Installation Manual

2

Install batteries in wireless devices

When system wiring is complete, install batteries in all devices. Make sure
batteries are inserted properly (see polarity marks on illustrations below).

Thermostat

Remote control (optional)

3

Link all devices to wireless network

Press
CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
necessary.
Install 2 fresh AA
batteries
Install 3 fresh AA
batteries
again if
CONNECT
Español: vea la página 20 • Français : voir la page 39
Outdoor air sensor (optional)
Restore AC power, then press the
button at the EIM and wait for green
flashing light to begin linking devices to
the wireless network (see pages 6-7).
If the light stops flashing before you
have linked all devices, press
again.
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.
5
Programmable models only
Install quick reference card
Install 2 fresh AA
lithium batteries
CONNECT
Continued on next page
CONNECT
>>