Replacing System Components; Remote Control & Outdoor Sensor; Equipment Interface Module (Eim); At The Remote Control - Honeywell RedLink Installation Manual

Replacing system components

Thermostat
To replace a thermostat, install batteries and follow the procedures on
pages 5-6 to link it to the wireless network. If necessary, modify settings as
needed (see tables on pages 9-11).
Remote control & outdoor sensor
To replace a remote control or outdoor air sensor, install batteries and
follow the procedures on pages 5-7 to link it to the wireless network.

Equipment interface module (EIM)

After installing a new EIM, you must re-set the thermostat and remote
control to communicate with the new EIM, as described below.
At the thermostat:
1 Press and hold the
2 Press twice to display Function 39 (wireless setup).
BACK
▼
3 Press to change Function 39 setting to 0 (disconnect from old EIM).
4 Follow the procedures on pages 5-6 to link to new EIM.

At the remote control:

1 Press and hold the blank space (or arrow if present) in the lower right
corner of the screen until the display changes (about 3 seconds).
2 Press
REMOVE
3 Follow the procedure on page 7 to link to new EIM.
▲
and
FAN
, then to disconnect from old EIM.
YES
Español: vea la página 20 • Français : voir la page 39
buttons for 3 seconds.
Press and hold for
about 3 seconds
15