Advertisement
INSTALLATION DESCRIPTIONS
1. Open the battery cover and put the battery inside, then cover it.
2. Use the USB to charge when the monitor is lack of power.
3. Outdoor camera connects with E- lock and power introduction.
(1) Diagram
12V + GND
NO
COM
NC
BATTERY
12V+ GND
NC
COM
NO
1
2
3
4
5
6
COM
NC
power supply
- 11 -
(2) Installation
Step1:
Dig installation
hole
Step4:
Tighten screw
F A I L U R E D I A G N O S I S
1. Fail to call.
Whether indoor monitor is on
Whether outdoor camera is very far away from the indoor monitor
Whether there is wrong match between outdoor camera and indoor monitor
2. Bad connection. Whether noise index is higher than 50dB
Whether outdoor camera is very far away from the indoor monitor
3. Low volume in speaking state. Whether protective material is uncovered
Whether the volume is adjusted to be too low
4. Close Alarm.When have alarm from camera and monitor.
First step: Fix the camera screw at the bottom well. At this time, still have alarm.
Second step: Press the unlock button to close the alarm.
Step2:
Fix rain cover
Step3: Fix
botton panel
- 12 -
Advertisement
