Advertisement
Place thread on spool pin I and lead thread end through holes
in thread guides 2 and 3 and through both thread retainer
openings 4 (see illustration opposite).
Pull thread between any two of the tension discs 5, (Fig. I) and
lead it clockwise (Fig. II) until it snaps into the square notch in
the tension cup (Arrow, Fig. Ill). The thread passes underneath
the thread check spring which holds it down permanently.
Bring take-up lever 7 as high as it will go and pass thread from
right to left through one of the holes at its end. Pull thread into
slots at left of thread guides 8 and 9, and then into the slot at
left of needle clamp 10.
Then thread needle, front to back. PFAFF's Automatic needle
threader will do this for you easily and quickly.
11
18
HI
Advertisement
