Set Lock Code; Auto Demo - JVC 0903-TN-II-VP User Manual

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the M
To SET LOCK CODE
π †
è
To operate (lock icon
Press Z
ERO
The first digit will be highlighted
è
To select the number
To move to the next digit
π †
Continue to follow these directions for all four numbers
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
When a viewer attempts to watch a blocked channel,
this message appears:
The channel will remain blocked until the correct lock
code is entered (see above for information on setting
your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.

Auto Demo

This function lets you preview the many different viewing
modes of your TV. It will cycle through "Multi Screen Demo",
"Picture in Picture Demo", all of the different "Aspect" ratios
and all of the different "Video Status" modes.
Press the M
To AUTO DEMO
π †
è
To turn AUTO DEMO ON or OFF
Note:
• To stop auto demo, press the M
buttons, and turn it off by pressing the
button
ENU
appears)
to access the lock code
button
ENU
button, and select auto demo by pressing the π †
ENU
THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
è
buttons. Press the M
Initial Setup
SET LOCK CODE
LOCK CODE
PRESS TO FINISH
OK
SELECT OPERATE
NO. - - - -
INITIAL SETUP
PREVIOUS
AUTO TUNER SETUP
CHANNEL SUMMARY
V-CHIP
SET LOCK CODE
AUTO DEMO
NEXT PAGE
SELECT OPERATE
button to finish.
ENU
0000
EXIT
MENU
OFF
EXIT
MENU
37