Set Up And Connections - JVC 1008WKT-NF-MT Instructions Manual

Set up and connections

LT-32EX18
Power lamp
ON : Lit (Blue)
OFF : Unlit
Power lamp lights
while the TV is on.
• "Power Lamp" (P. 11)
Remote control sensor
Care when setting
■ Power requirements
• Connect the power cord only to a 110-240V, 50/60Hz AC outlet.
■ When attaching the TV to the wall, use the optional JVC wall
mounting unit
• Consult a qualifi ed technician.
• JVC assumes no responsibility for damage due to improper mounting.
• 200 mm x 200 mm mount which conforms to VESA standards. (Except model LT-26EX18)
• 200 mm x 100 mm mount which conforms to VESA standards. (For model LT-26EX18 only)
■ Installation requirements
• To avoid overheating, ensure the unit has ample room.
200 mm
150 mm 50 mm 150 mm 50 mm
LT-32EX18
4
Switch between
TV/VIDEO
TV / VIDEO devices
MENU/OK
Display on-screen menu / set
Change channel / Page /
CHANNEL
Hyper Scan Function (P. 3)
Volume / Adjust
VOLUME
Power On / Off
To Headphone (P. 5)
• To prevent the TV from falling thread the
belt through the hole on the back of the
stand and secure it to the TV rack.
Hole for belt
Belt (not
provided)
Screw (not provided)
Connect an aerial and VCR / DVD Player
LT-32EX18
VIDEO-2 VIDEO-2
L V
R
VCR (DVD Player)
• After all the connections have been made, insert the plug into an
AC outlet.
Stand Assembly
- Insert the stand into the panel at the position where the screw
holes are, and fasten the screws.
1
LT-32EX18
- If you have any problem with assembly, please contact a retailer or
a dealership.
Note: 4 screws included.
AERIAL
OR
2