Table of Contents
Advertisement
7 PLAYBACK AND SPECIAL-EFFECTS PLAYBACK
7-1 Basic operation
Operation
1. Turn the power ON.
Check the connections and set the [POWER] switch on
the rear panel to ON.
2. Start playback.
Press the [PLAY] button. The [PLAY] indicator on the
display panel lights and playback starts.
3. Stop the playback temporarily.
Press the [STILL] button. The [STILL] indicator on the
display panel lights and the Still mode is engaged.
4. Re-start playback.
Press the [PLAY] button to start playback again.
5. Stop playback.
Press the [STOP] button to stop playback.
Playback
● Press the [PLAY] button to start playback from the point
where playback was last stopped.
Previous playback
Playback starts
from the position
where the playback
was last stopped.
Memo:
● The screen may go black or sound may be interrupted
during transitions between events.
POWER
WARNING
SLEEP
Beginning of the hard disk (full)
Event 1
Event 2
Event 3
Event 4
End of the hard disk (0%)
TIMER
CANCEL
MENU
DISPLAY
SEARCH
REC
STOP
PLAY
STILL
[STOP] button
[STILL] button
[PLAY] button
Memo:
● When the <REC MODE> switch in <ALARM/SENSOR
MODE> is set to "SENSOR" ("SN-***" is shown on
screen), the following phenomena may occur.
• The playback picture appears to stop for a moment or
sound is interrupted.
● If no signal is input from the selected camera during
recording, the picture may freeze or a black screen
may be displayed.
Simultaneous Playback mode
● Lets you check a recording while recording is taking place.
● Jog/shuttle playback and skip search are available in
addition to normal playback.
● When the [PLAY] button is pressed, playback starts from
the point where playback was last stopped.
Memo:
● When an alarm signal is received, the playback picture
may appear to stop or sound may be interrupted.
However, this does not affect the recording.
DIGITAL VIDEO RECORDER VR-510U
REC
REV
FWD
CLOCK RESET/ CLEAR
OPE. LOCK
EXECUTE
ON
SKIP/ALARM
SEARCH
31
Advertisement
Table of Contents
