Table of Contents
Advertisement
Main
Sub
Contents
code
code
26
43
Side void amount setting
(SIDE VOID)
62
Energy-save mode copy
lamp setting (C-LAMP E-S)
30
01
Paper sensor status display
(P-SENSOR)
[Function]
When this test command is executed, the currently set code of the side void quantity is displayed (ini-
tial display), and the set data are saved. (Setting range: 0 – 10, Default: 4 (= One side 2.0mm))
9
Code
Setting
0
0 mm
1
0.5 mm
2
1.0 mm
3
1.5 mm
4
2.0 mm
5
2.5 mm
6
3.0 mm
7
3.5 mm
8
4.0 mm
9
4.5 mm
10
5.5 mm
∗
When the adjustment value is increased by 1, the side void is changed as follows:
Side void adjustment: The side void is increased by 0.5mm. (The side void of "Set value x 0.5mm"
is made.)
[Operation]
1) Initial display
26-43 SIDE VOID
4( 0-10)
[Function]
Used to set half-ON /OFF of the copy lamp in the pre-heat mode.
When this test command is executed, the current set code number is displayed. Enter the desired
code number and press [ENTER/START] key to save the setting.
Code number
0
Copy lamp OFF
1
Copy lamp half-ON
[Operation]
The operation is similar to test command 21-01.
[Function]
The paper sensor status is displayed on the LCD.
Sensor
Paper exit sensor
No. 1 tray paper width sensor
Paper entry sensor
Duplex sensor
No. 2 tray paper feed sensor
New drum cartridge sensor
∗
Since the manual paper feed sensor is a single bypass sensor, its status is not displayed.
∗
The width sensor is available only in the FAX models.
[Operation]
1) Initial display
30-01 P-SENSOR
AR-168N/168L TEST COMMAND, TROUBLE CODES 10 - 15
Details of function/operation
Remark
Default
[
2)
10KEY]
26-43 SIDE VOID
5( 0-10)
Setting
Display item
OFF
ON
Display item
POD
PD1
PPD1
PPD2
PPD3
DRST
2) When sensor ON
30-01 POD
PD1
PD2
PPD1 PPD2 PPD3 DRST
3) [ENTER/START]
26-43 SIDE VOID
5( 0-10)
Remark
Default
Remark
Advertisement
Table of Contents
