Sharp AR-168N Service Manual page 83

Main Sub
Contents
code code
10 00 Toner motor operation
(TONER MOTOR)
14 00 Cancel of trouble other than
U2 (TRBL CANC.)
16 00 U2 trouble cancel (U2 TRBL
CANC.)
20 01 Maintenance counter clear
(M-CNT CLR.)
21 01 Maintenance cycle setting
(M-CYCLE)
22 01 Maintenance counter display
(M-CNT)
[Function]
When [ENTER/START] key is pressed, the toner motor is rotated for 30sec.
After completion of this process, the machine goes into the main code entry standby mode.
[Operation]
1) Initial display
10-00 TONER MOTOR
EXECUTING...
[Function]
Used to cancel troubles other than U2.
∗
Cancel troubles such as H trouble which writes data into EEPROM, and perform hardware reset.
[Operation]
1) Initial display
14-00 TRBL CANC.
CLEARED
[Function]
Used to cancel U2 trouble.
When [ENTER/START] key is pressed, check sum of the total counter in the EEPROM is rewritten
and hardware reset is made.
[Operation]
1) Initial display
16-00 U2 TRBL CANC.
CLEARED
[Function]
When [ENTER/START] key is pressed, the maintenance count value is cleared and "000,000" is dis-
played.
[Operation]
1) Initial display
20-01 M-CNT CLR.
CLEARED 000,000
[Function]
The code of the currently set maintenance cycle value is displayed (initial display) and the set data
are saved.
Code
0 3,000 sheets
1 6,000 sheets
2 9,000 sheets
3 13,000 sheets
4 25,000 sheets
5 Free (999,999 sheets)
[Operation]
1) The current set value is
displayed.
21-01 M-CYCLE
4:25,000 ( 0-5 )
[Function]
The maintenance counter is displayed.
[Operation]
1) Initial display
22-01 M-CNT
***,***
AR-168N/168L TEST COMMAND, TROUBLE CODES 10 - 8
Details of function/operation
Setting Remark
Default
[→
2) /10KEY]
21-01 M-CYCLE
5:FREE ( 0-5 )
←
2) [ /10KEY]
21-01 M-CYCLE
3:13,000 ( 0-5 )
3) [ENTER/START]
21-01 M-CYCLE
5:FREE ( 0-5 )