Table of Contents
Advertisement
❖ Information
The next time you connect to a Wi-Fi network, the
password is saved in the terminal.
When the terminal is connected to Wi-Fi network
successfully, "Connected" appears. When a different
message appears, make sure the password (security
key).
When "Connected" does not appear even if you enter
a correct password (security key), the correct IP
address may not have been acquired. Make sure the
signal status and reconnect.
* It may take 5 minutes or more to display the
message after [Connect] is tapped.
To use docomo service via Wi-Fi, setting "Wi-Fi option
password" is required. To set, from the Settings
screen (P.202), tap [docomo service]
for docomo apps]
u
[Wi-Fi option password].
Wi-Fi network status icons on status
bar
The following icons appear according to the
Wi-Fi network connection status.
Appears when connected to Wi-Fi network.
Appears when communicating via Wi-Fi
network.
Appears when connected to Wi-Fi network using
Auto IP function.
Appears when any Wi-Fi open networks are
*
detected.
* Set Wi-Fi Network notification to on with the
terminal not connected to Wi-Fi network beforehand
(P.204).
Disconnecting a Wi-Fi network
1
2
3
Wi-Fi network status
When you are connected to a Wi-Fi network
or when there are Wi-Fi networks available in
your vicinity, you can see the status of these
Wi-Fi networks. You can also set the terminal
u
[Wi-Fi settings
to notify you when an unsecured Wi-Fi
network is detected.
Setting the Wi-Fi open network
notification to ON
You need to turn on the Wi-Fi setting
beforehand (P.203).
1
2
3
From the Settings screen (P.202),
tap [Wi-Fi].
Tap the Wi-Fi network that is
currently connected.
Tap [Forget].
From the Settings screen (P.202),
tap [Wi-Fi].
Tap
and [Advanced].
Mark "Network notification".
Settings
204
Advertisement
Chapters
Table of Contents
