Printer Paper; Changing Paper; Paper Specification - Wayne Ovation Installation & Operation Manual

4.10 Printer Paper

4.10.1 Loading Paper
The following procedure refers to Figure 4-1(A -D).
1. Unlock and open the printer door on the dispenser bezel.
2. Pull down the inside printer door from top (A).
3. Important:
While holding the paper roll, pull the roll tight (B) and ensure there are no loops underneath
the roll.
4. Place paper roll inside the printer and feed from top of roll through the chute(C)
and (D).
5. While pulling slightly on the paper, push the door up to the closed position.
6. Wait for the printer to print the test receipt.
7. Cut receipt, close and lock printer door.

4.10.2 Paper Specification

The Clamshell printer in Ovation model dispensers uses the same thermal paper as the printer in
Wayne 3/Vista series dispensers. For reference, our thermal paper specification is as follows:
_____________
Basic weight: (gm./sq. meter) 58.0+/- 5.0
Caliper (in.): .0023-.0028
Elmendorf Tear (mg):
Main direction 20 (min.)
Cross direction 20 (min.)
Smoothness - Berk seconds 250-550
Base Paper- Kansaki P-300
Thermal Characteristics:
Paper shall not display a visual change in the background color during use and/or storage under
cyclic conditions of temperature ranging between -5C to 52C with variable humidity ranging between
0% and 90%.
Thermal Response Range:
Initiation 75C / 167F
Functional 85C / 185F
Developed Image: Black
Paper Roll Configuration:
Inside Core Diameter
Core Annular Thickness .10"-.28"
Paper and Core Width 2.32"-2.36"
Finished Roll Diameter 3.80"-4.00"
Residual Particles:
The annular area represented by the sheared edges of the paper, both sides, shall not have more than one parti-
cle per square inch nor more than five particles in total per annular surface area. The test for particles shall con-
sist of impressing the adhesive side of a one inch square, or equivalent, strip of black adhesive tape against the
surface; removing the strip of tape and examining the adhesive surface for adhering particles.
40
Part No. 920559 Rev H
- Koehler KT55F18
.68"-.79"
November 2008