Blinds; Status 550 Aerial P - Bailey Unicorn Owner's Manual

32. REMIS REMIBASE PLUS WINDOW

BLINDS.

Please note the blinds should not be in the closed
position when the vehicle is travelling or when in storage
for extended periods.
The sunscreen is housed at the bottom and the flyscreen
at the top of the blind. To open either hold the cross bar
and pull up or down. Both blinds can be fully extended
to totally cover the window or can meet at any position
to give sun shading/privacy and protection from insects
entering the vehicle.
The blinds are pre set to the correct tension.
If re tensioning is required please follow these steps:
The blind needs to be taken down from the wall by
unscrewing the 4 corner screws.
Lay the blind face down on a table with the cross bars of
both blinds meeting in the middle.
The black cords re-tension the fly screen and the white
cords re-tension the sun screen.
The cords are fixed at either side with a screw. Loosen
this screw and gently pull the cord 5mm tighter and
repeat on the other side ensuring the crossbar is level.
Test the tension. This process can be repeated if
necessary.
The blinds over the kitchen sink and in the bathroom
are of a different construction and can be re-tensioned
while fixed to the wall. On the side of the cassettes are
two plastic screw heads. Using a screw driver turn these
gently clockwise until the correct tension is reached.
Test the tension after each turn.
Cleaning:
The actual plastic profiles can be cleaned with a non
abrasive cleaner and damp soft cloth. The blinds should
only be dusted lightly with a soft cloth.
The blinds over the kitchen sink and in the bathroom
have a special sun screen that can be cleaned with a non
abrasive cleaner and damp cloth. The fly screens should
only be dusted with a soft cloth.
33. STATUS 550 DIGITAL ANTENNA
SYSTEM
Frequency Range:
Antenna Forward Gain 7db
Amplifier Gain
Gain Adjustment
Noise Figure
Output Impedence
Output
Power Supply
Power Consumption
Signal Outputs 2 TV 1 Radio
Travelling
Do not travel:
• With the Antenna Raise.
• With the Antenna set for vertical signals.
• When travelling adjust the antenna so that it points
to the rear of the vehicle to reduce the possibility of
damage when travelling.
Operating
Firstly determine the approximate location of the nearest
transmitter and whether the signals are horizontally
or vertically polarised.
operator or check other antennas in the vicinity.
1. Loosen the Mast Locking Collar and raise the
antenna. Rotate the mast to direct the Antenna
towards the TV Transmitter.
The H/V Indicator on the bottom of the mast indicates
the back of the Antenna.
2. Should you need to receive vertically polarised
signals rotate the winder, anti-clockwise to cant the
antenna through 90º.
DO NOT use undue force on the winder
3. Switch ON the Amplifier and the LED will illuminate.
4. Check the gain control is set to maximum.
maximum rotate clockwise.
5. Tune your television into the strongest signal. You
UHF 470-860 MHz
FM 88-108 MHz
DAB 175-230 MHz
16db
15db
2.8 db
75 ohms
95 dbuv
12-24 vDC
55ma
For assistance ask your site
For
80