HARTFORD CG-125 Service Manual page 54

Hartford Industrial Co., Ltd.
Remove the jets,float needle and
needle valve seat.
Note: Do not damage the jets
Remove the idle mixture screw
Note: Before removing the idle
mixture screw. Screw the adjuster
screw in. Fully counting the turns
The standard position for the idle
screws two turns back form fully
screwed in.
7.2.5Installing the float and
float needle
Inspect all parts for wear or damage
and replace as necessary.
Note: Take care during reassemble
not to damage any of the parts.
Reassemble the float needle and
needle seat.
Install the jets and idle mixture screws.
Replace the float bowl
7.2.6Replace the throttle slide
Replace the needle ,Needle lock clip
and needle lock spring
Replace throttle cable
Replace the missing chamber cap
and the air filter connecting hose.
Check the free closing of the throttle
at all handlebar positions.
7.Carburetor
Throttle valve
Idle mixture screw
Float
NO CG
7-4
Page
Main
needl
Float needle
Support pin
Needle lock spring
Needle
Needle lock clip