Before starting the generator
Ground terminal
The generator ground terminal is connected to the frame of the generator, the
metal non-current-carrying parts of the generator, and the ground terminals of
each receptacle. Before using the ground terminal, consult a qualified
electrician, electrical inspector or local agency having jurisdiction for local
codes or ordinances that apply to the intended use of the generator.
Assembly
Unscrew the tank cover. Remove the measuring jug and fit it into the recess on the
bottom of the tank cover. Screw the tank cover back onto the tank. Use the enclosed
screws to fasten the carry handle onto the tank.
Important! Before use, the tank needs to be filled up with a petrol mixture in a mixing
ratio of 50:1. Refer to the table below.
Use the measuring jug inside the tank. One increment equals 20ml. Mix the mixture
thoroughly.
Mixture 50:1
Regular unleaded petrol
1l
2l
3l
4l
For general use you can use 2-stroke oil.
Filling up the tank
•
Use petrol/oil mixture only
•
Remove any powercords
•
Turn power switches off
•
Do not overfill – leave air gap at top of the fuel tank
•
Always fully tighten the fuel cap
•
Clean up any spilled fuel
•
Do not smoke while refuelling or operating the generator
Always use caution!
AFTER SALES SUPPORT
PGM6003 Ma EN-IRL 1202-15.indd 10
2 stroke oil
20ml
40ml
60ml
80ml
10
0203-5142281
1800-719901
GB
IRL
www.servotool.eu
AF
WGG-800
2/15/12 9:35 AM