Receiver Setting - Aetertek AT-216F Owner's Manual

beep and vibrate once and the red LED light will be on. This is to indicate the receiver is in
charging status. Receiver will be charged in full after 3-4 hours with the blue LED light on.
When unplugged, receiver will beep and vibrate once. (Note: please don't forget to replace
the charge port cover lid).
2.Press and hold Power button for 3 seconds, receiver will beep and vibrate once to
indicate receiver is powered on. If the transmitter is on standby, the receiver will pair/sync
with the transmitter automatically. At this point, the system is on working status.
5
Open the package, take out the receiver and install the
metal prongs; charges the receiver for the first use. To
prolong battery life, recommend to charge the receiver
about 3-5 hours for the first few charges.
1.When receiver is connected to the wall charger, it will

Receiver setting