Aetertek AT-216F Owner's Manual page 5

O
distance between the emission level and reference signal coverage. Adjust the level according to user
needs. Level 00-10 is the strength level display of coverage signal; the higher the value
the coverage distance is. The center of the display will show the reference distance range
of the current level (note: in some special environment, when there is difference between
3
p e r a t n i g Guide
1.Open the package, take out the transmitter, align the RF
antenna at the RF connector, rotate clockwise and tighten the nut.
2.Plug the charger into the DC jack of the transmitter, the
transmitter will standby of emission; the antenna symbol in the
display starts flashing, indicating the transmitter is ready. The
lower right corner shows the current power. 。
3.The transmitter coverage distance can be adjusted by up
and down buttons; the center of the display shows the current
T r a n s m i t t
(
e r S e t t n i g
is, the larger
)