1. Manuals
  2. Brands
  3. PARKZONE Manuals
  4. Toy
  5. J-3 Cub BL
  6. Instruction manual

PARKZONE J-3 Cub BL Instruction Manual

Charge-and-fly park flyer
Hide thumbs Also See for J-3 Cub BL:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
PKZ4515
0 5 4 8 2 0 1 2 4 7
6
5
ParkZone
®
products are distributed exclusively by
Horizon Hobby, Inc.
4105 Fieldstone Road
Champaign, IL 61822
©2007 Horizon Hobby, Inc.
www.parkzone.com
10601
J-3 Cub BL

Instruction Manual

Charge-and-Fly™ Park Flyer
Wingspan: 37.25 in (946mm)
Overall Length: 26.75 in (680mm)
Weight: 15 oz (425 g)
Motor: PKZ370 Outrunner brushless motor, 1500Kv
FM Radio System: ZX10 3 proportional channels

Advertisement

Table of Contents
loading

Related Manuals for PARKZONE J-3 Cub BL

Summary of Contents for PARKZONE J-3 Cub BL

  • Page 1: Instruction Manual

    J-3 Cub BL Instruction Manual PKZ4515 0 5 4 8 2 0 1 2 4 7 ParkZone ® products are distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, IL 61822 ©2007 Horizon Hobby, Inc. www.parkzone.com 10601 Wingspan: 37.25 in (946mm) Charge-and-Fly™...

  • Page 2: Battery Capacity

    Congratulations on your purchase of the ParkZone® J-3 experienced radio control pilot during your first several 3. Place wing on top of fuselage so that it is Cub BL. Your J-3 Cub BL has come with everything flights. centered. needed to get you in the air—all in one box! You will 4.
  • Page 3 1/4 in approx. and replace the battery door. to the aircraft or injury. (6mm) 1/4 in 6. Your J-3 Cub BL has a built-in throttle-arming (6mm) Right Left feature which needs to “see” the throttle slider in Down the Off position before it will spin the propeller.
  • Page 4 2. Be sure the throttle slider is in the “Off” position. • A large, open grassy field is required to fly your J-3 Cub BL . The J-3 Cub BL flies about 15–20 Fly in this area mph, so it covers ground fast. The bigger the (upwind of pilot).
  • Page 5 Elevator Trim Lever Elevator Trim Flying If your J-3 Cub BL wants to go up or down, use 1. After launching, your J-3 Cub BL will climb at Rudder the trim lever located at the left of the stick to Trim Lever full throttle.

  • Page 6: Success Tips

    “flare” the plane. With some practice, your severe, or if the wings and/or tail are bent, replace low and it is time to land. Bring in your J-3 Cub BL landings should become smooth and on target. the damaged parts prior to flying again. See this...

  • Page 7: Troubleshooting

    BEC (like the Ultimate BEC), or receiver 5. Battery charging: Only use a battery charger J-3 Cub BL is shown on stickers on the back of the • Programmable timing—2 user-selectable ranges pack and switch using the following items to ensure for use with a large variety of brushless motors intended for use with the flight battery.
  • Page 8 WARNING: For your safety, when checking the The plastic case area next to the small BEC heat sink is 5. When you have made a valid selection the you plug the battery into the controller, so beware of using startup function of the ESC or making programming partially charged packs, as the system cannot protect your Li-Po designed to accept Velcro®...

  • Page 9: Warranty

    Damage Limits: Error Codes: The controller will beep continuously if the input HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS voltage is below the cut voltage (beep...beep...beep) OR PRODUCTION OR COMMERCIAL LOSS IN ANY WAY CONNECTED WITH THE PRODUCT, WHETHER SUCH when the battery is connected.

  • Page 10: Follow-Up Procedures

    PKZ4500 J-3 Cub BL RTF ....... 199.99 Electronics and engines requiring inspection or repair should be shipped to the following address: PKZ1102 Decal Sheet: J-3 BL.

Table of Contents