Table of Contents
Advertisement
6.2.6. CN22: Software Reset
Pin
1
2
The software reset is a means to manually reset the appliance temporarily back to manufacturer's default settings.
NOTE: VR-N100U rackmount systems do not utilize the manual software reset option.
6.3.
BIOS
The settings for the customized Phoenix-Award BIOS for the industrial server board have been optimized for the VR-N100U
security application. No changes to the CMOS are required.
6.4.
Adaptec SCSI BIOS
The onboard Adaptec SCSI BIOS settings for the server board have been for the VR-N100U security application. No changes
to the Adaptec SCSI BIOS are required. The default settings are:
SCSI Controller ID
SCSI Controller Parity
SCSI Controller Termination
Sync Transfer Rate (SCSI ID #0~15)
Initiate Wide Negotiation
Enable Disconnection
Send Start Unit Command
BIOS Multiple LUN Support
Include in BIOS Scan
Reset SCSI Bus at IC Initialization
Display <Ctrl><A> Message During BIOS Initialization
Extended Init 13 Translation for DOS Drives > 1 GByte
POST Display Mode
SCSI Controller Int 13 Support
Domain Validation
Support Removable Disks Under Int 13 as Fixed
Page 82 of 98
VR-N100U USERS MANUAL
Signal
Reset
GND
Adaptec Settings
All Items Are Subject To Change Without Notice
Defaults
7
Enabled
Enabled
160 MB/Sec
Yes
Yes
Yes
No
Yes
Enable
Enable
Enable
Verbose
Enabled
Enabled
Disabled
Feb. 2004 Rev 1.0
Advertisement
Table of Contents
