6.2.
Jumper Settings
The Industrial Server Board utilizes multiple default jumper settings for use with the VR-N100U security appliance and they are
outlined in the following sections.
6.2.1. JP1: Flash Disk
Options
Master
Slave
The embedded VR-N100U operating system and application are stored on a non-volatile flash disk that is attached to
the IDE 0 Channel. The setting for the flash should always be set to MASTER and no other device should be
attached to the IDE 0.
NOTE: DO NOT attempt to change the Flash Disk default setting on your VR-N100U unless instructed by Technical
Support personnel.
Page 80 of 98
VR-N100U USERS MANUAL
Settings
1-2: Short
1-2: Open (default)
All Items Are Subject To Change Without Notice
Feb. 2004 Rev 1.0