Download Print this page
York TG9S Technical Manual

York TG9S Technical Manual

95.5% single stage gas-fired residential multi-position gas furnaces

Advertisement

TECHNICAL GUIDE
95.5% SINGLE STAGE
GAS-FIRED RESIDENTIAL
MULTI-POSITION GAS FURNACES
MODELS: TG9S
NATURAL GAS
40 - 130 MBH INPUT
Due to continuous product improvement, specifications
are subject to change without notice.
Visit us on the web at www.york.com
Additional rating information can be found at
www.ahridirectory.org
WARRANTY
Lifetime limited warranty on both heat exchangers to the orig-
inal purchaser; a 20-year limited warranty from original instal-
lation date to subsequent purchaser.
10-year warranty on the heat exchanger in commercial appli-
cations.
Standard 5-year limited Parts warranty.
Extended 10-year limited parts warranty when product is
registered online within 90 days of purchase for
replacement or closing for new home construction.
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
DESCRIPTION
These compact units employ induced combustion, reliable hot
surface ignition and high heat transfer aluminized tubular heat
exchangers. The units are factory shipped for installation in
upflow or horizontal applications and may be converted for
downflow applications.
These furnaces are designed for residential installation in a
basement, closet, alcove, attic, recreation room or garage and
are also ideal for commercial applications. All units are factory
assembled, wired and tested to assure safe dependable and
economical installation and operation.
These units are Category IV listed and may be vented either
through side wall or roof applications using approved plastic
combustion air and vent piping.
FEATURES
Easily applied in upflow, horizontal left or right, or downflow
installation with minimal conversion necessary.
Compact, easy to install, ideal height 33" tall cabinet.
Blower-off delay for cooling SEER improvement.
Easy access to controls to connect power/control wiring.
Built-in, high level self diagnostics with fault code displays
standard on integrated control module for reliable operation.
Low unit amp requirement for easy replacement application.
Single wire twinning or staging feature available.
All models are convertable to use propane (LP) gas.
Electronic Hot Surface Ignition saves fuel cost with
increased dependability and reliability.
100% shut off main gas valve for extra safety.
4 speed, direct drive PSC motor.
24V, 40 VA control transformer and blower relay supplied for
add-on cooling.
Hi-tech tubular aluminized steel primary heat exchanger.
Secondary heat exchanger made of corrosion resistant
stainless steel materials.
Timed on, adjustable off blower capability for maximum com-
fort.
Blower door safety switch.
Solid removable bottom panel allows easy conversion.
Airflow leakage less than 1% of nominal airflow at duct-
blaster conditions.
No knockouts to deal with, making installation easier.
Movable duct connector flanges for application flexibility.
Quiet inducer operation.
Inducer rotates for easy conversion of venting options.
Fully supported blower assembly for easy access and
removal of blower.
External air filters used for maximum flexibility in meeting
customers IAQ needs.
Protection included from air intake, exhaust vent, or conden-
sate blockage.
Venting applications - may be installed as either 2-pipe
(sealed combustion) or single-pipe vent (using indoor com-
bustion air).
No special vent termination required.
1/4 turn knobs provided for easy door removal.
Internal condensate trap design (patent pending) provides
condensate management options, easy visual operation,
and is self-priming to prevent nuisance problems.
400991-YTG-E-0210

Advertisement

loading

Summary of Contents for York TG9S

  • Page 1 Due to continuous product improvement, specifications are subject to change without notice. • Inducer rotates for easy conversion of venting options. Visit us on the web at www.york.com • Fully supported blower assembly for easy access and removal of blower.
  • Page 2: Cabinet & Duct Dimensions

    400991-YTG-E-0210 RIGHT SIDE LEFT SIDE FRONT Combustion Air Inlet Combustion Air Inlet Condensate Drain Gas Pipe Gas Pipe Condensate Drain (Downflow) Entry Entry (Downflow) Vent Outlet Electrical Electrical Entry Entry Vent Outlet Condensate Drain Condensate 23” Drain Thermostat Wiring Thermostat Optional Return Air Wiring 14”...
  • Page 3: Filter Performance

    400991-YTG-E-0210 FILTER PERFORMANCE Concentric Vent Termination - For use through rooftop, side- wall. Allows combustion air to enter and exhaust to exit through The airflow capacity data published in the “Blower Perfor- single common hole. Eliminates unslightly elbows for a cleaner mance”...
  • Page 4 400991-YTG-E-0210 Blower Performance CFM - Any Position (without filter) - Bottom Return Bottom Airflow Data (SCFM) Models Speed Ext. Static Pressure (in. H2O) High 1128 1077 1035 Medium High TG9S040A08MP11 Medium Low High 1360 1290 1230 1165 1103 1043 Medium High 1251 1198 1140...
  • Page 5 400991-YTG-E-0210 Blower Performance CFM - Any Position (without filter) - Left Side Return Left Side Airflow Data (SCFM) Models Speed Ext. Static Pressure (in. H2O) High 1131 1091 1053 1003 Medium High TG9S040A08MP11 Medium Low High 1431 1375 1304 1244 1178 1109 1040...
  • Page 6 NOTES Subject to change without notice. Published in U.S.A. 400991-YTG-E-0210 Copyright © 2010 by Johnson Controls, Inc. All rights reserved. Supersedes: 400991-YTG-D-0409 Johnson Controls Unitary Products 5005 York Drive Norman, OK 73069...

This manual is also suitable for:

Tg9s040a08mp11Tg9s060a10mp11Tg9s060b12mp11Tg9s080b12mp11Tg9s080c16mp11Tg9s080c22mp11 ... Show all