Download Print this page

Garmin StreetPilot c320 Setup Manual page 6

Streetpilot c320
Hide thumbs Also See for StreetPilot c320:

Advertisement

Mount Your c320
1
Fit the bottom of your
c320 into the cradle of the
suction cup mount (1).
Tilt your c320 back until
it snaps in place (2).
2
Place the suction cup on your
windshield. Be sure the lever
is flipped toward you, as
shown to the right.
Note: To ensure a tight grip, make
certain your windshield is clean and
dry before you mount the suction
cup.
WARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the c320 installed to
place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the
driver's view of driving conditions, or cause personal injury in the event of an accident.
NOTICE TO STATE OF CALIFORNIA DRIVERS: California Vehicle Code Section 26708 (a) (1) provides that drivers in
California should not use suction mounts on their windshield or side or rear windows. Other garmin dashboard or friction
mounting options should be used. For available accessories, refer to the garmin web site at www.garmin.com. Also, refer to
the Owner's Manual for instructions on using the included mounting disk with the suction cup mount.
lever

Advertisement

loading