Reset Base Settings To Default; Registration - VTech VT2020 User Manual

1. Press <Menu> and <UP/DOWN> to select Base Settings
2. Press <Select> and <UP/DOWN> to select Modify PIN
3. Press <Select> and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
Note: If the old system PIN is incorrect, " Old PIN Invalid " is displayed and
will return to Modify PIN menu.
5. Press <OK> and enter the new system PIN.
6. Press <OK> and enter the new system PIN again.
Note: If the new PIN entered in Step 6 is not matched with the new system PIN entered in
Step 5, user is requested to enter the valid system PIN again in Step 5.
7. Press <OK> to confirm.
8.2.5

Reset base settings to default

You can reset your phone to the default settings. After reset, all you personal settings
and call list entries will be
deleted, but your phonebook and the stored SOS number(s) remain unchanged.
1. Press <Menu> and <UP/DOWN> to select Base Settings
2. Press <Select> and <UP/DOWN> to select BS Default
3. Press <Select> to enter the 4-digit system PIN (Default 4-digit system PIN: 0000)
4. Press <OK> to confirm.
5. Press <OK> to reconfirm.
Note: If the PIN code is entered correctly and is confirmed to restore the HS settings
to default settings,
"Reset"
will display. If the PIN code is entered incorrectly, "PIN Invalid" will display.
8.3

Registration

Your handset and base station is pre-registered. Up to six handsets can be
registered to a single base station.
If for some reason, the handset is not registered to the base station (<Antenna icon> is off),
register your handset
1. Press and hold <PAGE> on the base station for about five seconds,
the base station is entered into registration
2. Press <Menu> and <UP/DOWN> to select Registration .
3. Press <Select> and <UP/DOWN> to select the base station.
4. Press <Select> to enter the 4-digit system PIN.
5. Press <OK> to confirm.
If the handset registration is successful, you will hear a confirmation tone and the
<antenna icon> will stop flashing.
The handset will automatically be allocated the next available handset number.
This handset number is shown in
18
according to the following procedure.
the handset display in standby mode.
.
.
.
.
mode.