Installation; Equipment Description; Owner Responsibilities; Installing Dealer/Contractor Responsibilities - Briggs & Stratton Standby Generator Systems Installation & Start-Up Manual

Liquid-cooled generator system
Table of Contents

Advertisement

Installation

Equipment Description

This product is only for use as an optional generator system
which provides an alternate source of electric power and
to serve loads such as heating, refrigeration systems, and
communication systems that, when stopped during any
power outage, could cause discomfort or inconvenience.
NOTICE This product does NOT qualify for either an
emergency standby or legally required standby system as
defined by NFPA 70 (NEC).
• Emergency generator systems are intended to
automatically supply illumination, power, or both, to
designated areas and equipment in the event of failure
of the normal supply. Emergency systems may also
provide power for such functions as ventilation where
essential to maintain life, where current interruption
of the normal supply would produce serious life
safety or health hazards.
• Legally Required standby generator systems are
intended to automatically supply power to selected
loads in the event of failure of the normal source
which could create hazards or hamper rescue or fire-
fighting operations.
Every effort has been made to ensure that information in this
manual is accurate and current. However, we reserve the
right to change, alter, or otherwise improve the product and
this document at any time without prior notice.
Only current licensed electrical and plumbing
professionals should attempt generator system
installations. Installations must strictly comply with all
applicable codes, industry standards and regulations.

Owner Responsibilities

• Read and follow the instructions given in the
operator's manual.
• Follow a regular schedule in maintaining, caring for
and using your generator, as specified in the operator's
manual.
• Carbon monoxide detector(s) MUST be installed and
maintained indoors according to the manufacturer's
instructions/recommendations. Smoke alarms cannot
detect carbon monoxide gas.
• Smoke detector(s) MUST be installed and maintained
indoors according to the manufacturer's instructions/
recommendations. Carbon monoxide alarms cannot
detect smoke.
If you have questions about intended use, ask your installer
or dealer or call 800-732-2989 between
8:00 AM and 5:00 PM CT.

Installing Dealer/Contractor Responsibilities

• Read and observe the safety rules.
• Install only an UL listed transfer switch that is
compatible with the generator.
• Read and follow the instructions given in this
installation and start-up manual.
• Installation must strictly comply with all applicable
codes, industry standards, laws, and regulations.
• Allow sufficient room on all sides of the generator for
maintenance and servicing.

Cold Weather Kit

If operating the generator below 30°F (-1°C), it is HIGHLY
RECOMMENDED that a Cold Weather Kit be installed.
Cold Weather Kit, Part No. 6270 includes:
• Battery warmer, Part No. 6182
• Engine block heater, Part No. 6269
Battery warmer and engine block heater are also sold
separately.
These items are available at your local servicing dealer.
If you need more information on this matter, please call
800-732-2989, between 8:00 AM and 5:00 PM CT.
30°F (-1°C)
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents