Light Pattern/Sound Pattern Adjustment - Sirius Satellite Radio Mind State Optimizer User Manual

To use AudioStrobe
1. Choose Mode U1
Plug one end of the patch cord (included with your sys-
tem) into the headphone output of your CD player. Plug
the other end into either of the audio jacks located on the
side of the unit (below the DC adapter input). Plug your
headphones into the remaining jack.
2. Select U1 and start your CD player
You may adjust the sensitivity of Audio Strobe's response
to the signal by adjusting the left-hand dial. Adjust the
brightness with the right-hand dial. Start by setting these
approximately in the middle range. To temporarily stop a
session press the pause key on your CD player.
3. Make volume adjustments on your CD player
User Mode 2 (U2): Manual Mode
Use this mode to select a light/sound pulse rate from
1–30 pulses per second, using the
dition to changing pulse rate you can also toggle between
two different light patterns. (See Focus and Expand, page
11.)
Manual Mode is ideal for finding out which frequencies pro-
duce the most interesting patterns, the most vibrant colors,
10
the clearest visualizations, or the greatest mood changes.
For example, if you find that 7.8 Hz seems to work espe-
cially well for you, you can work with that rate as often as
you like.
(Up/Down) key. In ad-
To use Manual Mode
1. Choose Mode U2
2. Adjust the audio pitch
Before starting your session, use the
adjust the pitch. NOTE: In this mode the volume is preset
when you adjust the pitch.
3. Begin the session
Press the (Start/Stop) key to begin the session.
Use the (Up/Down) key to adjust the light/sound pulse
rates.
Frequencies ranging from 1 to 20 are adjustable in incre-
ments of 1/10th of a pulse per second; ranges from 20 to
30 are adjustable in increments of one pulse per second.
Light pattern / Sound pattern adjustment
in Manual Mode
You can create two completely different sound and light ef-
fects with this feature. You can toggle between these two
/
U
patterns by pressing the (Mode) key during a Manual
session. The left and right decimal points on the display will
provide you with a visual indication of the pattern you are
using. This is also true while running a pre-programmed
session except that the pattern is internally controlled and
cannot be adjusted by you.
Expand - The lights and sound will alternate from left to
right. The decimal points on the LED will alternate as well.
Focus -The lights blink on/off in sync. The decimal points
on the LED display will blink together.
(Up/Down) key to
11