Instructions For Use - Sirius Satellite Radio Mind State Optimizer User Manual

Instructions for Use

Battery Installation
Slide open the battery compartment cover on the back of
the unit and install three AA batteries. We suggest using
alkaline batteries for longest life. Do not use rechargeable
NiCad batteries; they run at a slightly lower voltage than
standard batteries and may prematurely trigger the low bat-
tery warning. Always use the a matched set of batteries. Do
not leave batteries in the unit for extended periods of time
as they can leak chemicals that can damage the unit.
Low battery warning: When the batteries drop below a
predetermined voltage level, the display will blink with the
word "Lo". At this point you may not be able to run a session.
Please replace the batteries.
External DC power: You may purchase an optional 7.5v
200ma adapter to help to conserve battery life. (The USA
package includes one; outside the USA this varies from
country to country). Note that this supply is NOT a battery
charger. If you are locating your own supply, it should be
rated 200-300 ma, 5 to 7 volts DC, plug sheath is ground.
Headphones and Lightframes
6
Plug the headphones into either audio jack (on the right
side of the unit, below the DC adapter input).
Plug your Lightframe glasses into the jack located on
top of the unit. (See Controls, page 5.)
Playing a session
1. Turn on the unit
Slide the On/Off switch to the On position.
The first thing you will see is the number "01" in the dis-
play. This indicates that Session 1, Power Regeneration,
is ready for use. (The unit will always default to session
01 when first turned on.)
2. Select a session
You may choose any of the Preset sessions (1–23) by
pressing the (Up/Down) key. The session number is
indicated in the LED display (01, 02, 03 . . .).
Use the (Up/Down) key to adjust the audio pitch before
starting your session. This can only be adjusted prior to
the start of your session.
3. Begin a session
Select the desired session. (See Session descriptions,
page 19.) Simply press the
Close your eyes as soon as the session begins.
NOTE: Two blinking decimal points on the LED display
indicate that a session is running. Prior to starting a ses-
sion, the numbers in the LED display indicate session
number; after starting, they indicate frequency, which will
change as a session progresses.
4. Adjust the volume and brightness
5. Ending a session
Press the (Start/Stop) key or turn off the Sirius to
end your session. To preserve battery life, always turn the
unit off when you are finished.
(Start/Stop) key to begin.
7