System Set Menu - Advantage MicroTron Installation Manual

4.

SYSTEM SET MENU

This menu is used to configure the controller to
specific operational needs. Some of the items in
this menu may not apply depending on the controller
model but will always be present.
PASSWORD - If a value of 0000 is entered,
a password is not required. If a password is
entered, it must be used to operate the controller.
If the first digit is 0, relays may be activated without
a password.
RESET WATER METER COUNT - Does not apply
unless the unit has selectable feed timer.
WATER METER IN - Select a contacting head
water meter or a paddle wheel flow meter.
GAL/PULSE - If a feed timer is using a contacting
head water meter this tracks make-up volume by
entering the number of gallons a contact equals.
Use • key to change to pulse/gal for flowmeter.
LOW DRUM NO PUMP/PUMP LOW DRUMS - If
unit has low level alarms, allows the associated
feed timer to be forced off when drum is low.
BAUD RATE - For units ordered with the serial
line or modem option.
System Set continued on next page.
--SYSTEM SET--
PASSWORD XXXX
ENTER
ENTER To change password
ENTER Use numeric keys to set password
then press ENTER to accept.
RESET METER
ENTER Count zeroed
Dry Contact Head
ENTER To change to HALL EFFECT
English Units
ENTER Metric Units
GAL/PULSE
ENTER To change value
ENTER Use numeric keys to change gal/pulse
then press ENTER to accept.
BLEED/PULSE
ENTER To change value.
Use numeric keys to change gal/pulse
ENTER for bleed then press ENTER to
accept.
PUMP LOW DRUMS
ENTER To change LOW DRUM NO PUMP
BAUD RATE 200
ENTER To change baud rate