Input Panel; Control Codes; Cable Connection - NEC V463-TM Installation Manual

V463-TM Installation Guide
46" LCD Display

Input Panel

Bottom:
Side:

Control Codes

NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.

Cable Connection

Communication Protocol:
Interface: RS-232C
Communication: Asynchronous
Baud Rate: 9600 bps
Data Length: 8 bits
Note:
If so desired, jumper "Request to Send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND).
www.necdisplay.com
Parity: None
Stop Bit: 1 bit
Communication Code: Hex
NEC Display Solutions of America, Inc.
V463-TM
Rev 1.0
Page 10 of 10