2.3. Handling the PDT
This section offers the basic procedures for using the PDT.
Starting the PDT
2.3.1.
Press the Power key to turn on/off the PDT. If the PDT does not power on,
perform a cold boot. See section 2.6 Resetting the PDT.
CAUTION:
inserted in the PDT and the device is powered on for the first time.
Figure 2-13: Power-on splash screen
Power On/Power Off
2.3.2.
a) Turning the PDT On
Press the Power key
reset. See section 2.6 Resetting the PDT.
As the PDT initializes its file system, its splash screen displays for about 30
seconds. Every time you perform a cold reset, this screen will also appear.
To turn off the PDT, just press the Power key again. This action does not
actually turn off the PDT; it only puts the PDT into suspend mode. All running
applications remain as you left them, until you press the Power key again to
resume operation of the PDT.
The PDT boots and powers on automatically when a battery is fully
briefly. If the PDT does not power on, perform a cold
28
When the PDT is powered on
for the first time, it initializes its
system. A splash screen
appears for a short period of
time, followed by the desktop
screen.
Opticon
PHL 8000 series
User Manual