Honeywell RedLink Installation Manual page 12

RedLINK™ Installation Guide (TrueZONE™)
Verify proper setup
When wireless setup is complete, make sure the Connected light on the
wireless adapter is solid green (see below), then follow the steps in the
Checkout section of the TrueZONE installation guide to verify proper
operation.
Error codes (thermostat & remote control)
If E1 appears during setup, check error code number (right side of screen):
29 Attempting to connect incompatible wireless devices.
30 Verify that thermostat zone number matches number assigned at zone panel.
31 Verify that this zone number is configured at the zone panel as an RF thermostat.
34 Low signal strength. Move wireless device to a different location and try again.
38 Make sure Connected light on wireless adapter is flashing and you are 2+ feet away
from wireless adapter.
Wireless status light
• Solid green: wireless adapter is
working properly and communicating
with wireless devices.
• Flashing green: Linking to wireless
devices (light flashes for 15 minutes
after you press
• Solid red: Communication problem.
Check wireless adapter and other
wireless devices.
12
).
CONNECT