Video Plus; Video Plus+ Recording - JVC HR-XV1EK User Manual

Look up the PlusCode Number in an
appropriate TV programme magazine.
Select the desired TV programme for
recording and refer to the PlusCode
Number next to it.
Note:
• The built-in timer stores 8 memories. If
the "PROGRAM FULL" indication
appears, you must delete one memory
(see page 31).
• When the power supply is interrupted
for more than 30 minutes, the preset
programme is cleared. In this case,
you have to set the timer again.

VIDEO Plus+

registered trademarks of Gemstar Development Corporation.
The VIDEO Plus+ system is manufactured under license
from Gemstar Development Corporation.
Preparation
• Turn on the TV and select the VCR channel on TV.
• Make sure TV/VCR/DVD switch has been slided to VCR/
DVD. Then press VCR to select the VCR mode. (The VCR
indicator will light)
1
Press PROG..
Note: If any button is not
pressed within 60 seconds,
the Recorder switches
back to TV operation.
2
Enter the PlusCode
Number using number
keys.
• In case of an error, press
CANCEL and enter the
desired number again.
3
Press L or M to select ONCE, DAILY or WEEKLY.
ONCE = To record a
programme only once
DAILY = To record TV
programmes transmitted
daily
WEEKLY = To record TV
programmes transmitted
once a week.
4
Press OK. By the PlusCode Number, the entered data
appears on the screen.
Select your tape speed.
• If the entered Number
is not correct, the
indicator "PLUS CODE
ERROR" will appear.
Enter the correct number.
®
Recording
VIDEO Plus+ and PlusCode are
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
PLUSCODE NO.
DATE
START
END
CH
SPEED
PDC
SELECT :
:
SET
EXIT : MENU
NO. : 0–9
:
: CANCEL
: OK
: PROG.
57378
NO. : 0–9
:
: CANCEL
: OK
: PROG.
57378
NO. : 0–9
:
: CANCEL
: OK
: PROG.
57378
15 FRI
17:30
18:00
3
SP
OFF
OK : OK
27