Reboot; Warm Boot; Cold Boot - Honeywell VX6 User Manual

Vehicle mount computer microsoft windows ce 5 operating system

Hide thumbs Also See for VX6:

Table of Contents

Reboot

When the Windows desktop is displayed or an application begins, the power up (or reboot) sequence is complete.

Start > Run

The Warm Boot function refreshes the Windows operating system without clearing RAM or deleting installed programs. User-

set parameters are unchanged.

Tap Start > Run and type WARMBOOT.EXE or WARMBOOT. This command is not case sensitive. Tap the OK button. This

process takes less than 15 seconds. Temporary data not saved is lost.

Note:

There may be slight delays while the wireless client connects to the network, re-authorization for voice-enabled

applications completes, Wavelink Avalanche management of the VX6 startup completes, or Bluetooth relationships

establish or re-establish.

Start > Run

The Cold Boot function reboots the device, erases all registry data, and user-specified settings. The factory default settings are

restored when the VX6 powers on again.

Passwords are lost upon cold boot. If a password is set, that password must be entered to begin the cold boot power cycle

process.

Tap Start > Run and type COLDBOOT.EXE or COLDBOOT. This command

command is located in the \Windows folder.

Note:

Because of the extreme nature of cold boot, Honeywell recommends using this command only as an emergency (or

when instructed to do so as part of a specific VX6 procedure).

The text typed in the text box can be upper or lower case or a combination of upper and lower case letters.

2-12

is not case-sensitive

. Tap the OK button. This

Table of Contents