Input/Output Setting - JVC DR-MX10SEK Instructions Manual

Input/Output Setting

9
The SCART connector supports the
connection of composite video signals.
Settings must correspond with the type of
video signal to use and the device to
connect.
IMPORTANT:
.. . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . .
0
For normal use, you can leave the default settings as
they are.
0
See the following page regarding each setting. Setup
Menu AF-1 INPUTB, AL-1 OUTPUTB, AL-1 INPUTB,
P114] h - k
AL-2 SELECTB [
0
During progressive scan, viewing is not possible as
the images are distorted.
Possible combinations
L-2 SELECT (*1)
VIDEO/RGB
S-VIDEO/RGB
SAT VIDEO/RGB
DECODER
L-1 INPUT
VIDEO
S-VIDEO
*1 Switching to RGB signals is automatic.
*2 Component videos will be output from the [COMPONENT] terminal. Be sure to set to ACOMPONENTB if viewing via component
video.
*3 With this setting, signals from the [L-2 IN/DECODER] terminal will be output to the [L-1 IN/OUT] terminal even if this unit is
turned off, except during EPG data downloading.
*4 This setting cannot be made if AL-2 SELECTB is set to ASAT VIDEO/RGBB or ADECODERB.
B D
-
A, E
SCART VIDEO SCART S-VIDEO
(*4)
A
Access the setup menu.
B
Select "FUNCTION SET UP".
C
Select "VIDEO IN/OUT".
SELECT
D
Set the input/output terminal.
A
Select and confirm on AF-1 INPUTB.
SELECT
CONFIRM
B
Select and confirm on AL-1 OUTPUTB.
C
Select and confirm on AL-1 INPUTB.
D
Select and confirm on AL-2 SELECTB.
0
See the description below for the combinations
of settings.
E
Exit setup.
L-1 OUTPUT
SCART RGB
FUNCTION SET UP
VIDEO IN/OUT
VIDEO
F-1 INPUT
S-VIDEO
COMPONENT (*2)
(*3)
(*3)
(*4)
EN I 29