Table of Contents
Advertisement
For Parts Call K&T 606-678-9623 or 606-561-4983
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
•
Reduce tire pressure to PSI shown in "PRODUCT
SPECIFICATIONS" section of this manual.
CHECK MOWER LEVELNESS
For best cutting results, mower should be properly leveled.
See "TO LEVEL MOWER HOUSING" in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual. Verify that the belts
are routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted. See "TO ADJUST
BRAKE" in the Service and Adjustments section of this
manual.
ASSEMBLY
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE
THE BEST PERFORMANCE AND SATISFACTION FROM
THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓ ✓ ✓ ✓ ✓ All assembly instructions have been completed.
✓ ✓ ✓ ✓ ✓ No remaining loose parts in carton.
✓ ✓ ✓ ✓ ✓ Battery is properly prepared and charged. (Minimum
✓ ✓ ✓ ✓ ✓ Seat is adjusted comfortably and tightened securely.
✓ ✓ ✓ ✓ ✓ All tires are properly inflated. (For shipping purposes,
✓ ✓ ✓ ✓ ✓ Be sure mower deck is properly leveled side-to-side/
✓ ✓ ✓ ✓ ✓ Check mower and drive belts. Be sure they are routed
✓ ✓ ✓ ✓ ✓ Check wiring. See that all connections are still secure
✓ ✓ ✓ ✓ ✓ Before driving tractor, be sure freewheel control is in
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ Fuel tank is filled with fresh, clean, regular unleaded
✓ ✓ ✓ ✓ ✓ Become familiar with all controls - their location and
✓ ✓ ✓ ✓ ✓ Be sure brake system is in safe operating condition.
✓ ✓ ✓ ✓ ✓ It is important to purge the transmission before operat-
9
www.mymowerparts.com
✓ ✓ ✓ ✓ ✓ CHECKLIST
1 hour at 6 amps).
the tires were overinflated at the factory).
front-to-rear for best cutting results. (Tires must be
properly inflated for leveling).
properly around pulleys and inside all belt keepers.
and wires are properly clamped.
drive position.
Engine oil is at proper level.
gasoline.
function. Operate them before you start the engine.
ing your tractor for the first time. Follow proper starting
and transmission purging instructions (See "TO START
ENGINE" and "PURGE TRANSMISSION" in the Op-
eration section of this manual).
Advertisement
Table of Contents
