Connecting The Power Cord - JVC VN-C655U Read Me First

Dome type
Hide thumbs Also See for VN-C655U:
Table of Contents

Advertisement

3 Connecting the Power Cord

Connect the camera to DC 18 V.
For a system with multiple VN-C655s
In a system where more than one VN-C655 are used, turn on the power for a VN-C655 first and then
setting the camera (
then turn on the power for a second one and go on to same setting. Repeat the procedure for the
other cameras.
Note
The IP address of VN-C655 is set to "198.168.0.2" at the factory. Proper access cannot be
established due to IP address redundancy if the power is turned on for multiple cameras at
one time under a single LAN environment. Do not turn on the power for multiple cameras
at the same time. If an IP address redundancy occurred, ensure that only one VN-C655 exists
on a single LAN environment and wait for some time (at least 10 minutes). Or turn off the
power once for all network equipment and turn it on again for proper access to VN-C655.
Page 28, Setting the IP Adress for VN-C655 with V.Networks Setup tool). Only
Connect the supplied AC adaptor to the DC 18 V
input terminal on the terminal stand.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vn-c655

Table of Contents