Table of Contents
Advertisement
MENU SETTING
MOTION DETECT Screen
Settings are executed about the motion detecting function that emits alarm signals when
there exists any motion in the image. Alarm signals are output from the auxiliary terminals on
the back.
Item
MODE
LEVEL
AREA EDIT
ALARM TIME
DEMONSTRATION
E-34
Functions and set values
This sets ON/OFF of motion detecting function.
OFF:
Motion detecting function does not work.
ON:
Motion detecting function works.
This sets the level that detects motion.
If the item MODE is set to OFF, "- - -" will appear, and
settings cannot be changed.
To function with large signal level change...decrease the
value
To function with small signal level change...increase the
value
[Set values: –5 to NORMAL to 5]
This sets the range in which the motion detecting function
works.
(
Page 39)
This sets the output time of the alarm signal output of
AUX terminal as well as "ALARM" display on the screen
when motion is detected.
If the item MODE is set to OFF, "- - -" will appear, and
settings cannot be changed.
[Set values: OFF, 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s,
1min]
MEMO
Even when the ALARM TIME item is set to OFF, an alarm
signal is output from the AUX terminal for about 500ms,
and "ALARM" is not displayed on the screen.
This is used when checking and confirming the set motion
detecting function. The detection area is shown in gray.
(
Page 39)
Initial value
OFF
NORMAL
–
10s
–
Advertisement
Table of Contents
