JVC KY-F550 Instruction Manual page 25

White Shading Adjustment (continued)
AUT O SHADING
OPERATION
AUT O SHADING
OK
AUT O SHADING
N G : OB J E CT
Object Error
AUT O SHADING
ERRO R : LO W L I GH T
Insufficient Illumination
AUT O SHADING
ERRO R : OVER L I G H T
Excessive Illumination
6.
Press the [AW] (Auto White) button for 1-2 seconds.
● When auto shading is activated, "AUTO SHADING
OPERATION" is displayed on the monitor.
● When auto shading adjustment is achieved, "AUTO
SHADING OK" will be displayed for about 3 seconds before
returning to the normal screen.
Caution
● When this unit is set as below, auto white shading cannot be
activated.
• When the "SHUTTER" item under "EXPOSURE" screen is
set to "SLOW".
• When the "MODE" item under "CAPTURE" screen is set to
"RANDOM TRG".
• When auto white is being activated.
● If white shading is to be adjusted when processing frozen im-
age, return to the normal screen before activating auto white
shading.
7.
Upon completing auto white shading adjustment, perform
white balance adjustment again.
☞ Page 22 'White Balance Adjustment'
Error Display
When auto white shading adjustment is not correctly ended, the
following message will be displayed for about 3 seconds.
● "NG : OBJECT" (Object Error)
Displayed when the object is not evenly white.
Change to an evenly white object and perform procedures again
to achieve auto white shading.
● "ERROR : LOW LIGHT" (Insufficient Illumination)
Displayed when the illumination is too dark. Open the lens ap-
erture or brighten the illumination and perform the procedures
again to achieve auto white shading.
● "ERROR : OVER LIGHT" (Excessive Illumination)
Displayed when the illumination is too bright. Close the lens
aperture or darken the illumination and perform the procedures
again to achieve auto white shading.
E-25