Introduction; Service Configuration; Service Tools - Nokia RH-128 Service Manual

RH-128

Service Tools

Introduction

This document explains relevant service software, service tools and handling instructions for RH-128.

Service configuration

Service tools
The table below gives an overview of service tools with Module jig that would be used in service testing,
tuning and error analysis.
Issue 1
CA-101
This cable provides a connection from the USB port of the personal
computer or notebook to the micro USB connector of the phone and
allows Point of Sale (POS) locations to flash the mobile terminal.
MJ-200
This jig allows PWB-level service and troubleshooting. It supports
regulated and unregulated DC input voltages, a headset jack for audio
tests and a RUIM card reader. It also supports simultaneous RF
connections to the CDMA engine.
AK05G-0650400W2
This AC power adapter (with 5.50mm power cord connector) is used to
provide DC power to the mobile phone and service tools (e.g. Module
Jig) from power supply for CDMA tuning (packaged with the module jig).
CA-128RS
This test cable is used for RF engine testing and tuning. It snaps directly
on the mobile terminal's RF connector and converts the output to a
surface mounting assembly connector.
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Data Service Cable
Module Jig
AC power adapter
RF Service Cable
Page 3-5