Table of Contents
Advertisement
10
EN
Power Switch
PAUSE
Lock
Button
Dioptre Adjustment
Control
GETTING STARTED
Grip Adjustment
1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp the
grip.
3
Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Viewfinder Adjustment
1
Set the Power Switch to "
down the Lock Button located on the switch.
2
Pull out the viewfinder fully.
3
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Tripod Mounting
1
Align the screw on the tripod with the camera's
mounting socket. Then tighten the screw.
•Some tripods are not equipped with studs.
CAUTION:
When attaching the camera to a tripod, extend its
legs to stabilise the camcorder. It is not advised to use
small sized tripods. This may cause damage to the
unit by falling over.
(cont.)
" or "
" while pressing
Advertisement
Chapters
Table of Contents
