Troubleshooting - JVC GR-DVL500 Instructions Manual

Jvc digital video camera instructions

Hide thumbs Also See for GR-DVL500:

Instructions manual (73 pages)

Instructions manual (72 pages)

Table of Contents

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,

etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery

pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed

as usual from the beginning.

SYMPTOM

1. No power is supplied.

2. "SET DATE/TIME!"

appears.

3. Recording cannot be

performed.

4. There is no picture.

5. Some functions are not

available using the MENU/

BRIGHT wheel.

6. The focus does not adjust

automatically.

7. The cassette will not load

properly.

8. Snapshot mode cannot be

used.

POSSIBLE CAUSES

1. • The power is not connected

properly.

• The battery is dead.

2. • The date/time is not set.

• The built-in clock battery

has run out and the

previously set date/time has

been erased.

3. • The tape's erase protection

tab is set to "SAVE".

• The Power Switch is set to

" or "OFF".

• "TAPE END" appears.

• The cassette holder cover is

open.

4. • The camcorder is not getting

power, or some other

malfunction exists.

5. • The Power Switch is set to

6. • Focus is set to the Manual

mode.

• The recording was done in a

dark place, or the contrast

was low.

• The lens is dirty or covered

with condensation.

7. • The cassette is in the wrong

position.

• The battery's charge is low.

8. • The Squeeze mode is

selected.