Playback; Basic Playback; Play/Pause Button; Fast-Forward Button [3] - JVC GR-DVL500 Instructions Manual

PLAYBACK

Basic Playback

Rewind Button (2)
Stop Button (5)
Speaker
Still Playback:
Pauses during playback.
1) Press 4/6 during playback.
2) To resume normal playback, press 4/6 again.
If still playback continues for more than about 3 minutes, the camcorder's Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorder's power is automatically turned off.
When 4/6 is pressed, the image may not pause immediately while the camcorder stabilizes the still
image.
Shuttle Search:
Allows high-speed search in either direction.
1) Press 3 for forward or 2 for reverse search during playback.
2) To resume normal playback, press 4/6.
During playback, press and hold 2 or 3 . The search continues as long as you hold the button.
Once you release it, normal playback resumes.
A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback:
1) Engage Still Playback.
2) Rotate the MENU/BRIGHT wheel towards "+" for forward Frame-By-Frame Playback, or towards "–" for
reverse Frame-By-Frame Playback during Still Playback.
To resume normal playback, press 4/6.
You can also use the provided remote control for Frame-By-Frame Playback (
Playback Zoom and Playback Special Effects
Available only with the remote control (provided) (

Play/Pause Button

1
(4/6)
Fast-Forward Button 2
(3)
Power Zoom
Lever (VOL.)
To Control The Speaker Volume . . .
NOTES:
Lock Button
Power Switch
Allows frame-by-frame search.
Load a tape ( pg. 12).
Set the Power Switch to "
the Lock Button located on the switch. To start
playback, press 4/6.
• To stop playback, press 5.
• Press 2 to rewind, or 3 to fast-forward the tape
during Stop mode.
.... slide the Power Zoom Lever (VOL.) towards "+" to
turn up the volume, or towards "–" to turn down the
volume.
If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to
"OFF", then to " ".
The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (
You can also view the playback picture on the LCD
monitor with it flipped over and pushed against the
camera body.
LCD monitor/viewfinder indications:
• When power is supplied from a battery: the "
battery pack remaining power indicator is displayed.
When power is supplied through the DC cord: "
does not appear.
• During Stop mode, none of the indications are
displayed.
When a cable is connected to the AV connector, the
sound is not heard from the speaker.
pg. 42, 43).
31
EN
" while pressing down
pg. 34).
"
"
pg. 42).