Advertisement
Installation Manual
PREPARING THE LUMINAIRE FOR INSTALLATION
Luminaires are shipped pre-assembled from the factory. The only field preparation required is that the pryouts at
the end of each luminaire must be removed and the quick-connect wiring inside must be withdrawn so that it may
be connected to the pre-assembled jumper cables. In some instances, a luminaire (or array of luminaires) will
terminate, and no wiring will be required into the last enclosure. The pryouts are intended to be left undisturbed in
these situations.
Step No. 1:
Remove pryout
Pryouts are to be left in
place if no wiring is required
into the end of a luminaire
FCLS-Slim Manual 8-11
Step No. 2:
Remove snap-on cover, discard
pryout slug and careully feed the
three quick connect terminals and
wire through the open hole
8020 Queenair Drive, Gaithersburg, MD 20879 USA • phone: 301 921 4120 • fax: 301 963 3050
email: info@CathodeLightingSystems.com • website: www.CathodeLightingSystems.com
Page 3
Step No. 3:
Replace snap-on cover
©2011 Cathode Lighting Systems Inc.
Advertisement
