JVC GR-DV1 Instructions Manual page 29

OFF
5S
STOP PLAY REW
/PAUSE
RE SHOOT
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this
procedure.
1 SELECT MODE
Set the Power Dial to "PLAY".
2 START SEARCH
Press PLAY, then press REW or FF. Watch in the
viewfinder for the spot where you want to
begin recording.
3
ENGAGE STILL MODE
Once you find the spot at which you want to
start recording, press PLAY/PAUSE to engage
the Still mode.
4 START RECORDING
Set the Power Dial to "REC" and press
RECORDING START/STOP.
FF
CAN.
NOTES:
RECORDING
START/STOP BUTTON
Starting at 00:00:00 (MIN:SEC:FRAME), the
camcorder records a time reference signal from
the beginning of the tape. See page 49 for
information about displaying Time Codes.
The video recording may not start from exactly
00:00:00.
The Time Code cannot be reset.
If you start recording from a blank portion in the
middle of the tape, the camcorder calculates the
approximate time code and records it. For this
reason, accuracy may suffer slightly during R.A.
Edit ( pg. 54) and Snapshot Search (
If you start recording from the end of the previous
recording leaving no blank space, there may be
situations where a clean transition is not possible.
29
OFF
5S
PLAY
/PAUSE
pg. 25).