Table of Contents
Advertisement
Installation of Wall Mounted Type Indoor Unit
1. Selection of the best location
There should not be any heat source or steam
•
near the unit.
• There should not be any obstacles to prevent
the air circulation.
• A place where air circulation in the room will be
good.
• A place where drainage can be easily obtained.
• A place where noise prevention is taken into
consideration.
• Do not install the unit near the door way.
• Ensure the spaces indicated by arrows from
the wall, ceiling, fence, or other obstacles.
The mounting wall should be strong and solid enough
to protect it from the vibration.
1) Mount the installation plate on the wall with
four Type "A" screws.
(If mounting the unit on the concrete wall, consider
using anchor bolts.)
• Always mount the Installation plate horizontally by
aligning the marking-off line by means of the
thread and a level.
2) Drill the piping hole with 70mm dia. holecore drill.
• Line according to the arrows marked on lower the
left and the rght side of the Installation Plate.
The meeting point of the extended line is the cen-
ter of the hole.
• Drill the piping hole at either the right or the left
and the hole should be slightly slant to the out-
door side.
The lower left and the right side of Installation Plate
2.1/7, 2.6/9, 3.5/12 [kW/Btu]
Left rear piping
80mm
ø70mm
Installation of Wall Mounted Type Indoor Unit
6
Right rear piping
50mm
ø70mm
Front
Down right
Right
Rear right
More than
5 cm
Higher than eye-level
marking-off line
Type "A" screw
Weight
Wall
Indoor
3.5/18 [kW/Btu]
Left rear piping
A
A
A
A
ø70mm
Left
Rear left
Lower than 2.3m
More than 5 cm
More than
5 cm
Installation Plate
Thread
Outdoor
Right rear piping
ø70mm
Advertisement
Table of Contents
