5-2
Once You Have Completed the Installation
Configure the ControlNet Communications Driver in RSLinx
Software
Follow this procedure to configure the ControlNet communication driver.
IMPORTANT
1. Install RSLinx software, version 2.42.00 or later, on your computer.
2. In RSLinx software, select Configure Drivers.
A. Click Communications.
B. Click Configure Drivers.
3. Select a driver for ControlNet devices.
Publication 1784-IN003D-EN-P - January 2006
Do not use these steps to configure a ControlNet
communication driver for any application that uses a
SoftLogix5800 controller. For information on configuring the
ControlNet card for use with SoftLogix5800 controllers, refer
to page 5-4.