Setting Up The Antenna - Traxxas Rustler 3705 Owner's Manual

Setting up the Antenna

Stampede
You must install the antenna mast (tube) before you operate your
model. You'll find the plastic antenna tube and tip in the bag with
your manuals and documentation.
Antenna
Tip
1. Locate the black antenna wire that exits the receiver.
2. Pull the wire straight with your fingers and then insert the end of
the wire into one end of the antenna tube. Push the wire all the
way through the antenna tube.
3. Pull the remaining wire through the antenna tube, and then insert
the base of the antenna tube into the molded post on the chassis.
4. Fold the remaining antenna wire over the top of the tube and
secure it with the antenna tip.
5. On the transmitter, always fully extend the telescoping antenna
when running your model. Make a habit of holding the transmitter
so that the antenna points straight up.
Antenna
Tube
Antenna
Mount
The Traxxas TQ Radio System
Rustler
Antenna
Tip
Antenna
Tube
Antenna
Mount
Spray a little window cleaner
on the antenna wire to make
it easier to push through the
antenna tube.
Don't shorten the length of
the antenna wire. Its length
is tuned to the frequency
band; cutting it could
severely shorten the radio
system's range.
Don't push the transmitter
antenna down from the
top. Pull it down from the
bottom, one segment at a
time, to prevent binding and
kinking the antenna mast.
Traxxas • 13