Traxxas RUSTLER VXL Owner's Manual
Hide thumbs Also See for RUSTLER VXL:
Table of Contents

Advertisement

owners manual
MODEL 3708
MODEL 3608
MODEL 2408
extreme brushless power system

Advertisement

Table of Contents
loading

Summary of Contents for Traxxas RUSTLER VXL

  • Page 1 owners manual MODEL 3708 MODEL 3608 MODEL 2408 extreme brushless power system...
  • Page 2 Thank you again for going with Traxxas. We work hard every day your model to assure you receive the highest level of customer satisfaction possible. We truly want you to enjoy your new model!
  • Page 3 Traxxas service needs. Maintenance and replacement Throughout this manual, you’ll notice warnings and helpful hints www.Traxxas.com parts may be purchased directly from Traxxas by phone or online identified by the icons below. Be sure to read them! E-mail: support@Traxxas.com at www.BuyTraxxas.com.
  • Page 4: Speed Control

    Safety Precautions All of us at Traxxas want you to safely enjoy your new model. Operate procedures for long life and safe operation. Warning: LiPo batteries are your model sensibly and with care, and it will be exciting, safe, and fun...
  • Page 5 • Philips screwdriver NiMH battery charger 8 AA alkaline 6 or 7-cell NiMH battery pack with Charging adapter - Traxxas part #3061 (peak detecting type recommended) • Soldering iron batteries Traxxas High-Current Connector (if your battery charger has a Molex connector) see sidebar TR A X X AS •...
  • Page 6 Front Bumper Gear Cover Receiver (ghosted) Shock (Oil Damper) Antenna Mount Spur Gear Upper Chassis Plate Front Shock Tower Slipper Clutch Servo Saver (not visible) Turnbuckle Suspension Steering Servo (Toe Link) Arm (Rear) (under Upper Chassis Plate) 6 • Traxxas...
  • Page 7 Shock Tower Wheelie Bar EZ-Set ® Button Receiver (On/Off Button) Steering Servo Pinion Gear Antenna Mount Spur Gear Turnbuckle (Rear Camber Link ) Gear Cover (ghosted) Front Body Mount Slipper Clutch Turnbuckle (Toe Link) Rear Shock Tower Traxxas • 7...
  • Page 8 Gear Cover Receiver (ghosted) Shock Antenna Mount (Oil Damper) Spur Gear Upper Chassis Plate Front Shock Tower Slipper Clutch Servo Saver (not visible) Turnbuckle Wing Mount Hole Suspension Steering Servo (Toe Link) Arm (Rear) (under Upper Chassis Plate) 8 • Traxxas...
  • Page 9 Quick Start: Getting up to Speed The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.
  • Page 10 Gluing Tires and Decorating Your Model Applying The Decals Installing The Bandit VXL Wing The main decals for your model have The Bandit VXL wing comes pre-installed. The instructions here are been applied at the factory. The decals to show you how to install a replacement wing in the future. are printed on self-adhesive clear mylar 1.
  • Page 11 The Traxxas TQ Radio and Velineon Brushless Power System model wiring diagram Your model is equipped with the Traxxas TQ Radio System. ESC/Motor Wiring Diagram The Traxxas TQ Radio System is a 2-channel system that Traxxas High-Current Antenna Connector (Male) provides high-power output up to a quarter mile.
  • Page 12 If the battery channel is referred to by its flag color and channel number, as pack is cold after 15 minutes send signals to your model. All Traxxas RTR models operate on a shown below. of charging, add another 27 MHz frequency band.
  • Page 13 The TQ Radio and Velineon Power System NiCad - Abbreviation for nickel-cadmium. The original rechargeable Transmitter - The hand-held radio unit that sends throttle and hobby pack, NiCad batteries have very high current handling, steering instructions to your model. high capacity, and can last up to 1000 charging cycles. Good Trim - The fine-tuning adjustment of the neutral position of the charging procedures are required to reduce the possibility of servos, made by adjusting the throttle and steering trim sliders...
  • Page 14 Male Charge Adapter 2-Pack Male Stick packs typically use thin spot welded To run this model, your batteries must be equipped with Traxxas Nickel strips to connect the cells. Look High-Current Connectors. Batteries can either be purchased new for the thickest metal strips (about the...
  • Page 15: Installing Transmitter Batteries

    The TQ Radio and Velineon Power System Installing Transmitter Batteries Installing the Battery Pack Place the battery pack into the battery compartment of the model Your TQ transmitter uses 8 AA batteries. The battery compartment Use the Right Batteries and then place the battery hold-down over the posts. Secure the is located in the base of the transmitter.
  • Page 16 The TQ Radio and Velineon Power System Setting up the Antenna Stampede VXL Rustler VXL Spray a little window cleaner and Bandit VXL You must install the antenna mast (tube) before you operate your on the antenna wire to make model.
  • Page 17 The TQ Radio and Velineon Power System TQ Radio System Controls There are two settings available: Steering Using Reverse: While driving, 50/50: Allows equal travel for both move the throttle trigger acceleration and reverse (default). forward to apply brakes. 70/30: Allows more throttle travel (70%) Once stopped, return the and less reverse/brake travel (30%).
  • Page 18 The TQ Radio and Velineon Power System TQ Radio System Rules 4. The on/off switch is integrated into the speed control. With the Channel 1 Remember, always turn the transmitter on, press and release the EZ-Set button (.25 seconds). Each time you prepare to run your model, you Brown TQ transmitter on first and The LED will shine GREEN (see warning, below).
  • Page 19: Adjusting The Electronic Speed Control

    Voltage Detection turned on. Low-Voltage Detection can be turned 4. When the LED blinks RED ONCE. Pull the Continuous current: off for a slight increase in run-time when using NiMH batteries. Traxxas throttle trigger to the full throttle position and 200A recommends leaving Low Voltage Detection on at all times.
  • Page 20 Adjusting the Electronic Speed Control 7. To turn the VXL-3s off, press the EZ-Set button until the LED turns blinking red (indicating the Profile numbers). off (.5 seconds). 3. When the LED blinks red three Patent-Pending Training times, release the EZ-Set button. VXL-3s Profile Selection Mode (Profile #3) reduces 4.
  • Page 21 Driving your Model Now it’s time to have some fun! This section contains instructions on About Run Time driving and making adjustments to your model. Before you go on, here A large factor affecting run time is the type and condition of your are some important precautions to keep in mind.
  • Page 22: Basic Tuning Adjustments

    Most will affect the overall width and the suspension geometry of the model. The offsets and dimensions designed into the model’s wheels are intentional; therefore, Traxxas Toe-in cannot recommend the use of other non-Traxxas wheels with different specifications.
  • Page 23 In loose dirt, a tire with large spikes should Stampede VXL Wheelie Bar Set-up Upper Arms perform better. See your parts list for accessory wheels and tires. The Traxxas wheelie bar comes standard Position To achieve a good starting with the Stampede VXL. It is available as...
  • Page 24 If the bottom of the shock is leaking, then it High performance vehicles speed control. is time for a rebuild. The Traxxas rebuild kit for two shocks is generate small vibrations 6. Check the tightness of the wheel nuts with a wrench.
  • Page 25 If you can’t find a solution for your the receiver. If it is plugged into the battery terminal, it will not go into model here, then visit our website at www.Traxxas.com/support. There you programming mode.
  • Page 26: Advanced Tuning Adjustments

    Advanced Tuning Adjustments Gearing Compatibility Chart: Gearing LiPo Batteries The chart below shows recommended gear combination ranges when using a One of the more significant advantages to your model’s transmission LiPo batteries are intended only for the most advanced users that are NiMH battery pack to power your model.
  • Page 27 3.5mm bullet An on-board temperature gauge such as the Optional sensored brushless motor wiring diagram: Wire size: Traxxas part #4091 can aid you in monitoring 12 Gauge your motor temperature. Generally, try to Current Ratings: keep your motor below 200° F. If necessary,...
  • Page 28 1100 Klein Road, Plano Texas 75074 1-888-TRAXXAS 070926 KC1081 Part# 3798X...

This manual is also suitable for:

Stampede vxlBandit vxl370836082408

Table of Contents