Leister Triac PID Operating Instructions

Hot air blower

Hide thumbs Also See for Triac PID:

Table of Contents

Download this manual

OPERATING INSTRUCTIONS

USA

LEISTER Triac PID

Hot Air Blower

Read operating instructions carefully before

use and keep it for further reference.

• Welding of thermoplastic materials as well as single-ply flexible plastics and

modified bitumen in the form of boards, tubes, profiles, lining membranes,

coated materials, films, foams, tiles, and sheets. The following procedures

are possible: overlap welding, welding with rod, with tape, butt welding

and melt welding

• Heating-up for forming, bending and sealing of thermoplastic semi-

finished materials and plastic granules

• Drying of water-damp surfaces

• Shrinking of heat-shrink sleeves, films, tapes, solder sleeves and moulded parts

• Soldering of copper pipes, solder joints and metal foils

• Defrosting of frozen water pipes

• Activating/dissolving of solvent free adhesives and fusion adhesives

• Igniting of wood shavings, paper, coal or straw in furnaces

LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen / Switzerland

Tel. + 41 41 662 74 74 Fax + 41 41 662 74 16

www.leister.com

sales@leister.com

Table of Contents

Do you have a question about the Triac PID and is the answer not in the manual?

Page 1: Operating Instructions
• Defrosting of frozen water pipes • Activating/dissolving of solvent free adhesives and fusion adhesives • Igniting of wood shavings, paper, coal or straw in furnaces LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen / Switzerland www.leister.com sales@leister.com Tel. + 41 41 662 74 74 Fax + 41 41 662 74 16...
Page 2 WARNING Danger to life when opening the tool as live components and connections are exposed. Unplug the tool before opening it. Incorrect use of hot-air blowers can cause fire and explosion hazard, especially near combustible materials and explosive gases. Do not touch heater tube and nozzle when they are hot. They may cause burns.
Page 3 • Check air flow and line/mains supply. • Set potentiometer (3) back to desired position and/or plug tool to the line/mains If the unit is still not functioning, contact a LEISTER service centre and provide details of the fault. Change of nozzles •...
Page 4 Have the tool checked by your Service Centre. The life of the brushes is about 1600 running hours of the welding tool’s motor. • Repairs should be carried out by authorised LEISTER Service Centres only. They guarantee a specialised and reliable Repair Service within 24 hours using original spare parts according to schematics and spare parts lists.