We reserve the right to change materials and specifications without notice. Proprietary Information The information contained in this document is the property of Harrison Consoles. and is proprietary to and a trade secret of Harrison Consoles. This document and the information contained herein and derived therefrom are not to be disclosed to any person without the express written consent of an duly authorized officer of Harrison Consoles.
“Where do I put my keyboard and mouse or trackball?” and “Where do I put my computer monitor/s?” The 950mx solves those issues by providing a 2-tiered front bolster which is wide and deep enough to comfortably locate your DAW keyboard and mouse/trackball (with sufficient cable access) along with a generous ‘flat’...
Input Meter - The four segment input meter is directly after the input section pre EQ and fader. Direct Out - The direct out is line level signal that is post EQ, filters, and fader. 950mx analog console overview v1.4 Page 8...
“BLACK” bus (2) provides an electronically balanced output stage. Input Meter - The four segment input meter is directly after the input section pre EQ and fader and is a sum of the left and right inputs. 950mx analog console overview v1.5 Page 9...
No front panel controls are provided for the mix bus insert points. Common practice is to enable the jumper and “normal” the insert point at a patch bay. 950mx analog console overview v1.5 Page 10...
Talkback Mic level knob controls the level of the condenser microphone provided. The TALK switch enables talkback to the assigned outputs on the Dual Mix Bus master module. 1/4” Headphone Jack The headphone output shares the source, mono/stereo, mute, and solo settings of the Main Speakers. 950mx analog console overview v1.5 Page 11...
MONO combines the left and right monitor sources and MUTE mutes the Alternate Output A output. Talkback Section Allows direct talk back to either Alternate Output A or Alternate Output B outputs. 950mx analog console overview v1.5 Page 12...
10.0 Specifications AUDIO SPECIFICATIONS The following specifications apply to Harrison 950mx consoles and are subject to change without notice. Harrison 950mx consoles will be tested to meet only those specifications in effect at the time of final testing. These specifications represent an overall system and not the individual components of a system.
11.0 Power Supply Specifications The 950mx includes the Harrison L-159 power supply and associated power cable. The included power cable is 10 feet (3.05 meters) in length. Custom lengths are available for additional cost. Input Specifications* minimum nominal maximum Input Voltages (AC)
Page 16
4. Push card firmly into module slot. 5. Slide fuse-pull lever to right into normal position and re-insert fuse into holders. 6. Use caution in selecting correct fuse value. 950mx analog console overview v1.5 Page 16...
12.0 Environmental Specifications The environmental requirements for the Harrison 950mx are no more restrictive than for any other piece of sensitive audio equipment. Please note the following requirements and recommendations: Ambient Air Temperature Limits Minimum 58.2ᄎ F (14.6ᄎ C) Maximum 85ᄎ F (30ᄎ C) Operation at the upper extremes of the temperature range is not recommended and may increase the failure rate of component parts.
Jump 1-2 to bypass insert. Jump 2-3 to activate insert. PGM 2R Insert Jump 1-2 to bypass insert. Jump 2-3 to activate insert. Control Room Module Jumper Settings Function Settings Mute on Talk Jump 1-2 to mute on talk (default). 950mx analog console overview v1.5 Page 18...
Need help?
Do you have a question about the 950mx and is the answer not in the manual?
Questions and answers